Safety Measures And Training The Final User; Use Of The Equipment; Controls; Setting The Goods On The Slicer Saddle - Diamond FAP250 Manual Del Usuario

ALL THE SLICERS OF THE SERIES "GRAVITY GPE" ARE MANUFACTURED SINGLE-PHASE
V.230/1/50 HZ.
WHENEVER THE VOLTAGE DIFFERS FRON THE ABOVE MENTIONED ONES, PLEASE APPLY TO
THE MANUFACTURER, OR THE AUTHORIZED DISTRIBUTOR.

3.3. SAFETY MEASURES AND TRAINING THE FINAL USER

THE SKILLED PERSONNEL IN CHARGE OF THE INSTALLATION AND ELECTRIC CONNECTIONS IS
RESPONSIBLE OF THE TRAINING OF THE FINAL USER, WHICH MUST ALSO BE INFORMED ON
THE SAFETY MEASURES TO COMPLY WITH.
THIS INSTRUCTION MANUAL COMES WITH EACH EQUIPMENT.

4.1. CONTROLS

THE CONTROLS AND PILOT LIGHT ARE SET ON THE RIGHT SIDE OF THE BASE WHEN THE
MACHINE IS PLACED IN FRONT OF THE OPERATOR. Fig.2
1. GREEN BUTTON FOR STARTING AND RED BUTTON FOR STOP THE EQUIPMENT
2. LUBRICATOR
3. KNOB FOR ADJUSTING SLICE THICKNESS
4.2. SETTING THE FOOD ON THE SLICER SADDLE
1. SET THE FOOD ON THE SADDLE WHEN THE THICKNESS ADJUSTING KNOBIS SET TO ZERO
AND WITH MOTOR OFF TO AVOID DAMAGING THE EQUIPMENT.
2. SET THE FOOD ON THE SADDLE AND BLOCK IT WITH THE FOOD-PRESS.
3. SET A HAND ON THE FOOD-PRESS AND START THE CUTTING.
4. WHEN THE FOOD IS FULLY SLICED USE THE FRONT PART OF THE FOOD-PRESS TO KEEP
THE FOOD AGAINST THE BLADE.
5. WHEN THE CUTTING IS OVER, PUT OFF THE MOTOR AND STOP THE SLICE THICKNESS ON
ZERO POSITION, THEN REMOVE THE FOOD FROM THE SADDLE. Fig.3-4
5) CLEANING AND MAINTENANCE OPERATIONS

5.1. GENERALITIES AND PRODUCTS FOR CLEANING

BEFORE CARRYING OUT ANY CLEANING OR MAINTENANCE OPERATIONS, CHECK TO MAKE
SURE THAT THE MAINS SWITCH BE OFF AND THE SUPPLY PLUG DISCONNECTED FROM THE
MAINS.
ACCURATELY CLEAN THE EQUIPMENT EVERY DAY FOR A CORRECT OPERATION AND LIFE OF
THE EQUIPMENT.
DESPITE THE SEVERAL SAFETIES, TAKE GREAT CARE TO AVOID CUTTING RISKS WHEN USING
THE BLADE.
CLEAN THE EQUIPMENT WITH THE USUAL NEUTRAL
CONTAIN SODA OR ALCOOL. WHEN CLEANING REMOVED ELEMENTS, DO NOT USE A DISH-
WASHER FOR NOT DAMAGING ANODIZED PARTS.
5.2. REMOVAL OF THE BLADE-COVER
1. LOOSEN THE KNOB OPPOSITE TO THE BLADE. Fig.5
2. PUSH THE KNOB TOWARDS THE BLADE AND RELEASE THE BLADE- COVER FROM ITS
HOUSING.
3. REMOVE THE BLADE-COVER FROM THE SLICER AND CLEAN IT WITH A WATER JET. Fig.6

4) USE OF THE EQUIPMENT

DETERGENTS WHICH MUST NOT
10