Saivod RA-1500-II Manual Del Usuario página 14

EN
ASSEMBLY INSTRUCTIONS
The heater is packaged with the feet unattached. You must attach them before operating the
heater.
WARNING: Do not operate without feet attached. Do operate the heater only in upright
position (feet on the bottom, controls on the top), any other position could create a
hazardous situation.
1. Place the radiator body upside-down on a scratch-free location, make sure it is stable and
will not fall.
2. Screw off the wing nuts from the U-shaped bolt provided (see Fig 1), attach the U-shaped
bolt to the U-facing flange between first and second fins (near the front cover) (see Fig 2).
3. To attach the castor mounting plate to the radiator body, you should insert the threaded ends
of the U bolt in the holes on the castor mounting plate (see Fig 3).
4. Screw the wing nuts back to the U bolt and fasten the wing nut properly (see Fig 4).
Note: do not over tighten, which may cause the damage of radiator flange.
5、Repeat 2, 3 and 4 on the rear of radiator for mounting of the rear castors.
Note: The rear castors must be mounted between the end two fins.
INSTRUCTIONS FOR USE
1. Before using the heater, make sure that it is on a flat and stable surface.Damage may occur if
it is placed on an incline or decline.
2. Set all the controls to OFF position and insert the plug into a socket-outlet with well
grounded. Be sure that plug fits firmly.
3. Rotate the thermostat knob clockwise to "MAX" position and switch the heater on as follow:
the switch "I" for low heat, the switch "II" for medium heat and both switches on for high heat.
4. When your room reaches the desired temperature, now slowly rotate the thermostat knob
counter clockwise until the pilot light goes out. The thermostat can now be left at this setting.
As soon as the room temperature has dropped below the set temperature, the unit will switch it
self on automatically until the set temperature has been reached again. In this way the room
temperature remains constant with the most economical use of electricity.
5. If you want to change the room temperature setting, rotate the thermostat knob clockwise to
raise the temperature, or counter clockwise to lower it.
6. This heater includes an overheat protection system that shuts off the heater when parts of the
heater are getting excessively hot.
7. To completely shut the heater off, turn all the controls to OFF, and remove plug from the
socket-outlet.