Specifications Of Standard Wiring Components; To Connect The Electrical Wiring To The Outdoor Unit; Finishing The Outdoor Unit Installation; To Finish The Outdoor Unit Installation - Daikin RXJ20M5V1B Manual De Instalación

8 Finishing the outdoor unit installation

7.1 Specifications of standard wiring
components
Component
Power supply cable Voltage
Phase
Frequency
Wire sizes
Interconnection cable
(indoor↔outdoor)
Recommended circuit breaker
Residual current device
7.2 To connect the electrical wiring to
the outdoor unit
1 Remove the service cover.
2 Open the wire clamp.
3 Connect the interconnection cable and power supply as follows:
a
a Interconnection cable
b Power supply cable
c Circuit breaker
d Residual current device
e Power supply
f Earth
4 Tighten the terminal screws securely. We recommend using a
Phillips screwdriver.
5 Install the service cover.
Installation manual
12
Class 20 Class
25+35
220~240 V
1~
50 Hz
3-core cable
2
2.5 mm2~4.0 mm
H05RN-F (60245 IEC 57)
4-core cable
2 2
1.5 mm ~2.5 mm and
applicable for 220~240 V
H05RN-F (60245 IEC 57)
10 A 13 A
MUST comply with
applicable legislation
50 Hz
c d
220-240 V
b e
f
3×
8 Finishing the outdoor unit
installation
8.1 To finish the outdoor unit
installation
DANGER: RISK OF ELECTROCUTION
▪ Make sure that the system is earthed properly.
▪ Turn off the power supply before servicing.
▪ Install the switch box cover before turning on the power
supply.
1 Insulate and fix the refrigerant piping and cables as follows:
d c
a
e
b
f
g
a Gas pipe
b Gas pipe insulation
c Interconnection cable
d Field wiring (if applicable)
e Liquid pipe
f Liquid pipe insulation
g Finishing tape
2 Install the service cover.
9

Configuration

9.1

Facility setting

Use this function for cooling at low outdoor temperature. This
function is designed for facilities such as equipment of computer
rooms. NEVER use in a residence or office where people occupy the
space.
Applicable for: RXM-R, ARXM-R, RXJ-M, RXA-A.
9.1.1

To set the facility mode

When cutting jumper J6 on the PCB, the operation range will expand
to –15°C. The facility mode will stop if the outdoor temperature drops
below –20°C and resume when the temperature rises again.
To cut jumper J6
1 Remove the top plate of the outdoor unit.
2 Remove the front plate.
3 Remove the drip proof cover.
4 Cut jumper J6 on the outdoor unit PCB.
a
a Front plate
b Top plate
c Drip proof cover
d Jumpers
RXJ-M(9)_RXA-A(9)_RXM-R(9)_ARXM-R(9)
b
c
d
J12 J8 J7 J5 J9 J4 J6
R32 Split system air conditioners
3P650253-1 – 2021.02