Programming The Remote Control; Fcc Compliance - Kohler 1013822-D Guía De Propietario

Using Your Remote Control (cont.)
Chromatherapy Cycle - Chromatherapy lights will automatically
and continuously cycle through the eight colors: white, violet,
indigo blue, aqua blue, green, yellow, orange, and red. One cycle
through all eight colors takes approximately one minute.
Chromatherapy Specific Color Selection - When this mode is
selected, you may choose a specific color for the bath.

Programming the Remote Control

IMPORTANT! Programming the remote control is required. Your
whirlpool will not respond to any remote control until you program
the remote. If you replace the remote control or replace the pump
control, it will be necessary to program the remote control.
NOTE: To program the remote you must turn off the breaker
controlling the power to the overflowing bath. Perform the
following steps within three minutes after restoring power.
When power to the overflowing bath is turned on, the pump
control switch will flash for three minutes. It flashes between
yellow and green.
Press the pump control switch to enter the learn remote function.
The pump control switch will flash green.
Press any button on the remote. The overflowing bath will only
respond to this remote.
NOTE: If you do not press any of the buttons on the remote within
three minutes, the overflowing bath will not respond to the remote
control.

FCC Compliance

FCC ID : N82-KOHLER001
Canada ID : 4554A-KOHLER001
Compliance Statement (Part 15.19)
This device complies with Part 15 of the FCC Rules and with RSS-210
of Industry Canada. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including
interference that may cause undesired operation.
1023581-5-C 4 Kohler Co.