Operating As A Blower - Ryobi RGBV3100 Manual Del Operador

OPERATING AS A BLOWER

1. Start engine. See Starting/Stopping Instructions.
2. Set the blower/vacuum mode change-over lever to
the up position (Blower Mode) (Fig. 13).
NOTE: Never use the unit with the lever in the halfway
position.
Change-over lever
Fig. 13 Fig. 19
3. Place the shoulder harness over your head and onto
your shoulder and adjust properly, see Installing
and Adjusting the Shoulder Harness.
Hold the blower as shown in Figures 14, 15, and 16.
Sweep from side to side with the nozzle several inches
above the ground or floor. Slowly advance, keeping the
accumulated pile of debris in front of you.
Most dry blowing operations are better suited to low
speed than high, while high speed is better for moving
heavier items like large debris or gravel.
Use the blower for trees, shrubs, flower beds and
hard to clean areas (Fig. 14).
Fig. 14
OPERATING INSTRUCTIONS
Vacuum
Mode
Blower
Mode
Use the blower around buildings and for other normal
cleaning (Fig. 15).
Fig. 15
Use the blower for walls, overhangs and screens (Fig. 16).
Fig. 16
13