METRICA 60821 Manual De Usuario página 12

- To move the beam step by step clockwise or counter-
clockwise, press the
- To switch to Scan mode, press the SPEED button until
the beam stops, then press SCAN/CAL.
Scan function
- When the self-levelling beam is at 0 rpm, press the
SCAN/CAL button successively to obtain the scan an-
gle: 10°/30°/60°.
- To rotate the scan angle, press the keys
SLOPE function to tilt the projected plane at will
- Press the TILT/SLOPE button.
- The green light to the left of the button lights up.
- Press the keys to move the projected plane.
- WARNING: The laser plane generated is not self-leve-
ling.
AUTOMATIC VERTICAL OPERATION
- Start with the instrument turned off
- Turn the instrument 90°, placing the "X" side of the in-
strument down.
Power on
- Press the I/O key
- The green light to the left of the key will flash.
- When the instrument is self-levelling, the green LED
stays on and the laser beam rotates constantly, genera-
ting a self-levelling vertical plane.
TILT function to signal unwanted movement
of the instrument
- Press the TILT/SLOPE button.
- The green LED on the left side of the button will light up.
- After 15 seconds, if the instrument is inadvertently mo-
ved, the LED to the left of the TILT/SLOPE button will
flash, the beam will stop and after 10 seconds the in-
strument will turn off.
SPEED function
- With the instrument switched on and self-levelling :
- Press the SPEED button successively to select the
speed: 600/300/0 rpm.
- To move the beam step by step clockwise or counter-
clockwise, press the keys
- To switch to Scan mode, press the SPEED button until
the beam stops, then press SCAN/CAL.
Scan function (SCANNER)
- With the meter off, press I/O
- Let the unit level itself
- When the self-levelling laser dot is at 0 rpm, press