Rapid EG320 Manual De Instrucciones página 5

• When applying at a height, take
all the necessary precautions to
ensure that the glue does not
run onto the operator or onto
any object. Make sure that you
have enough protection wear
(skin, eyes)
• Some materials are heat-
sensitive and can be damaged
by the hot nozzle or even the
hot glue. Whenever possible,
test a piece of scrap material or
a hidden portion of the object
being repaired.
• Stay alert. Pay attention to your
work. Beware of any dripping
hot glue from your project. Use
common sense. Do not operate
this gun when you are tired. Do
not operate under the influence
of alcohol or other drugs
that may impair your physical
abilities.
• When you have finished using
the machine, unplug it and
wait until it has cooled. Never
immerse glue gun in water or
other liquids to speed cooling
process. Allow it to air cool only.
The glue gun should be stored
in a closed dry and secure place
(tool box, drawer, cupboard,
etc.).
Instructions for Use
Plug the glue gun into a suitable
socket, red light on the switch
means the power is on.
• Allow the tool to heat for
approximately 3-5 minutes.
Insert a glue stick in the back of
the tool.
• When the gun is fully heated,
squeeze the trigger slowly, until
the melted material begins to
flow from the nozzle. Release the
trigger to stop the glue flow.
• Work with glue gun trigger to
adjust the output and speed of
the glue stick.
Changing Nozzle
• To change the nozzle, the glue
gun should be slightly warm but
unplugged.
• Unscrew the nozzle using
gloves.
Breakdowns and remedies
• To prevent the clogging of
this glue gun, keep feeding
mechanism and melt
chamber free from dirt and other
foreign debris.
• Store unused glue sticks in a
clean environment.
• Do not pull glue stick from the
back of the glue gun. The feed
mechanism may be damaged or
impaired. If you need to change
glue type, cut off the protruding
end and feed the remainder
through with the new glue stick.
• Do not lay the heated gun on its
side. Keep the heated gun in an
upright position, on the metal
stand or workbench, with nozzle
pointed down.
• If melted glue has escaped
from the melt chamber entrance
and is interfering with the
feed mechanism; allow gun to
5