Setting The Clock - Askoll NGS1 Manual Del Usuario

Setting the clock

• Press and hold the SELECT button for about 2
seconds: the two digits corresponding to the time
will start flashing.
• Press SELECT repeatedly to set the correct time.
• Press the SET button: the minute digits will start
flashing and the hour digits will return to fixed.
• Press SELECT repeatedly to set the correct
minutes.
• Press the SET button to exit the setting.
Since time is stored in the vehicle battery, in case of
two batteries, it is convenient to set the clock with both
batteries installed to synchronize time. In any case, if
there are two batteries, the time stored for the battery
in compartment A is always displayed.
For battery description
compartments A and B refer to chapter "BATTERY
AND RECHARGE".
NGS_Rev00_EN.indb 29 NGS_Rev00_EN.indb 29
NGS
A
SELECT
and positioning in
NGS
2
1
Km/trip
PWR
%
SET
- NGS
3
USE
EN
EN
EN
EN
EN
29
09/07/2020 17:08:47 09/07/2020 17:08:47