Battery Charger - Askoll NGS1 Manual Del Usuario

BATTERY CHARGER

Batteries are charged using the specific charger
supplied (MOD. TVC202).
The charger is activated only when connected to the
mains with its cable and to the vehicle or to a battery
through the socket. Once connected, all leds will flash
for a few seconds, and then indicate the remaining
battery depending on the amount of leds lit.
Using the MODE button on the battery charger to
change the charging mode between:
MAINTENANCE: press MODE until 2 leds flash (up
to 50), the battery is recharged up to 50%. Now it is
possible to leave the battery unused for longer periods
while preserving battery life.
LONG LIFE (90% recharge): this mode is recommended in periods when the scooter is frequently used to obtain
the best and prolonged operation of the batteries. For maximum system efficiency, it is recommended to alternate
1 100% charge cycle every 10 90% cycles.
This procedure allows to obtain a high number of charge and discharge cycles of the batteries, maintaining a good
charge percentage performance over time.
To select this mode press MODE until 4 leds start flashing (up to 90).
MAXIMUM CHARGE: default mode, press MODE until 5 leds flash (up to 100), the battery is recharged up to
100%. In this way there is maximum autonomy.
Charging time (NGS - NGS
1
Charging time (NGS ): from 1 to 6 hours (full charge starting from low battery).
3
NGS_Rev00_EN.indb 37 NGS_Rev00_EN.indb 37
): from 1 to 4 hours (full charge starting from low battery).
2
BATTERY AND RECHARGE
EN
EN
EN
EN
EN
37
09/07/2020 17:08:55 09/07/2020 17:08:55