Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
Fig. O
3
Removal and Installation of the Cutting
Cart (Fig. A, P, Q)
To Remove the Cutting Cart
1. Unlock the cutting cart stop
2. Slide the cutting cart off the tool.
Fig. P
Fig. Q
To Install the Cutting Cart (Fig. R)
1. Align rail guide rollers
26
rails
27
on the tool. Make sure the cutting cart lock pin
is in the unlock position.
2. Slide the cutting cart onto the tool.
3. Lock the cutting cart stop.
10
8
.
on the cutting cart to the
Fig. R
26
Types of Cuts (Fig. A, S)
WARNING: Do not make freehand cuts.
Always do a practice run to acquaint yourself with the path
of the blade. Practice on a scrap tile to ensure that you are
comfortable with the feel of the cutting operation. Push the
cart past the blade before turning the saw on.
Straight Cuts
1. Using a marker or grease pencil, mark the area to be cut
on tile.
2. Place the tile on the cutting cart against the cutting cart
fence
and align your mark with the blade.
7
3. Pull the on/off switch up to turn the saw on and wait for
the blade to be completely covered with water.
4. Ease the cutting cart toward the blade then slowly feed
the tile into the blade. Continue pushing until the blade
cuts completely through the tile.
nOTE: The flip hood on the splash hood can be rotated
up to help align the line on the tile with the blade.
5. Turn off the saw.
Diagonal Cuts
Diagonal cuts are also referred to as "long point to long
point cuts."
1. Install the edge guide.
2. Align the point of the tile closest to the cutting cart
fence
7
with the cut indicator
3. Align the front of the tile to the blade and hold against
the edge guide.
4. Turn the saw on and make the cut.
5. Turn off the saw.
27
30
.
Publicidad
Tabla de contenido
