To Connect Optional Accessories (Wired User Interface, Central User Interface, Wireless Adapter, Etc.); To Install The Wireless Adapter; To Set A Different Address - Daikin FTXP20L2V1B Manual De Instalación

Ocultar thumbs Ver también para FTXP20L2V1B:
Tabla de contenido

Publicidad

5 Installation
5.2.4
To connect optional accessories (wired
user interface, central user interface,
wireless adapter, etc.)
1 Remove the electrical wiring box cover (refer to
electrical wiring box cover" on
2 Attach the connection cable to the S21 connector and pull the
wire harness as shown in the following figure.
a
b
a
S21 wire harness routing for wireless adapter
b
S21 wire harness routing for other applications
c
S21 connector
3 Put the electrical wiring box cover back and pull the wire
harness around it as shown in the figure above.
5.2.5

To install the wireless adapter

For class 20, 25, 35
1
1 Place the wireless adapter against the hooks.
2 Lock the adapter by pressing it down.
3 For removal, perform the above steps in reverse order.
For class 50, 60, 71
Installation manual
12
"To remove the
page 8).
c
1
4 Place the wireless adapter into the holder.
5 Fix the adapter in the holder by pressing down on it.
6 For removal, bend one clamp of the holder with a finger to
release the wireless adapter and remove it from the holder.
5.2.6

To set a different address

In case 2 indoor units are installed in 1 room, different addresses for
2 user interfaces can be set.
1 Remove the batteries from the user interface.
2 Cut the address jumper.
a
a
Address jumper
NOTICE
Be careful NOT to damage any of the surrounding parts
when cutting the address jumper.
3 Turn the power supply on.
Result: The flap of the indoor unit will open and close to set the
reference position.
INFORMATION
▪ For FTXF-A units, the following setting MUST be
completed within 5  minutes after the power supply is
turned on.
▪ In case you could NOT complete the setting in time,
turn the power supply off and wait at least 1  minute
before turning the power supply back on.
4 Press simultaneously:
Model
Buttons
FTXP-L and ATXP-L
FTXF-A
5 Press:
(A)(F)TXP20~35L2V1B + FTXF20~71A2V1B
a
,
and
,
and
Daikin room air conditioner
3P512025-1 – 2017.11

Publicidad

Tabla de contenido
loading

Tabla de contenido