How To Wire Your Ceiling Fan - Pull Chain; Installing The Canopy Housing - Fanimation The Belleria FP4320-1 Serie Manual Del Propietário

How to Wire Your Ceiling Fan - Pull Chain

If you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a
licensed electrician.
WARNING
To avoid possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
1. Connect the green grounding lead from the hanger ball
and the green grounding lead from the hanger bracket to
the supply grounding conductor (this may be a bare wire
or wire with green colored insulation). Securely connect
wires with wire connectors supplied.
2. Securely connect the white fan motor wire to the white
supply (neutral) wire using wire connector supplied.
Securely connect the black fan motor wire and blue wire
to the black supply wire using wire connector supplied
(Figure 12). After connections have been made, turn leads
upward and carefully push leads into the outlet box, with
the white and green leads on one side of the outlet box
and the black and blue leads on the other side of the outlet
box.
3. Secure the ceiling canopy to the hanger bracket with
threaded rods, external lockwashers, and knurled knobs
provided (see page 11). Your fan is now wired to be turned
on and off from the fan pull chain speed control.
NOTE: This step is applicable after the necessary wiring
is completed.
WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and the
ceiling.
1. Remove one of the two shoulder screws in the
hanger bracket. Loosen the second shoulder screw
without fully removing it. Assemble canopy by
rotating key slot in canopy over shoulder screw in
hanger bracket. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that
was previously removed. (Figure 13a)
2. Securely attach and tighten the Canopy Screw
Cover over the shoulder screws in the Hanger Bracket
utilizing the keyslot twist-lock feature (Figure 13b).

Installing the Canopy Housing

Black
Fan Wire
Green Wire
(Ground)
Green Wire
(Ground) from
Hanger Bracket
Green Wire
(Ground) from
Hanger Bowl
HARDWARE USED:
WIRE
CONNECTORS
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not operate
fan until the blades is in place. Noise and motor damage
could result.
Figure 13a
8
Listed
Black
Outlet Box
White
Blue
Figure 12
x 3
WARNING
Figure 13b
Household
Supply