Compulsory Regulatory Checks - Tractel pal-turn Modo De Empleo

Maintenance inspections and operations must be performed by skilled persons and specialists.
§ First time use (or putting back in service) check with national regulations.
§ Compulsory periodical check in compliance with the national regulations. Recommended
every 12 months by TRACTEL SOLUTIONS SAS.
A thorough examination paying particular attention to any alteration of parts due to an
§
impact, corrosion, cracking or deformation must be conducted a minimum of twice a
year, every month in the case of heavy-duty use in an aggressive atmosphere.
TRACTEL SOLUTIONS SAS is at your disposal in order to conduct any regulatory check.
§
Before each use
Good condition of the straps is a guarantee for safety and functioning of the turnover system. It is
essential to verify constantly the good condition of the straps and to ensure good storage conditions.
Make a visual control of all components of the pal-turn™, and particularly check :
the turning bar,
§
§ attachment ring,
§ pulley and indexing lever
Verify position and condition of strap buckles. And ensure that the remote control works properly,
especially the emergency stop
Annual checks
§ Compulsory periodical check in compliance with the national regulations. Recommended
every 12 months by TRACTEL SOLUTIONS SAS. This annual control must include all
necessary examinations in order to detect any damage or potential problems that could
cause dangerous situations.
§ Check if equipment does not have any deformation, fissures or other defaults.
If upper hooking ring has more than 10 % wear, it must be replaced.
§
Check presence and legibility of signalling plate.
§
§ Check if the state of the pulley's surface pulley allows a good adherence of the straps
§ Remove the housing and check the tension of the chains
Grease the chains when necessary
§
§ Ensure that there is no spell of the bar on the bearings
§ Check the state of the pulley's indexing lever
§ Check if there are no vibrations when the device is working. Important vibrations may
indicate damage of the bronze bearings.
§ Ensure that the electrical connections and wiring are in good state
§ Ensure that the remote control works properly, especially the emergency stop
Note all controlled information on a register.
§
M 6067 M
rev 10 – 07/2020

COMPULSORY REGULATORY CHECKS

GB
Page 22/92
www.tractel.com