For Your Safety - Würth MLL08 Instrucciones Para El Manejo

GB
Working safely with the measuring tool
is possible only when the operating in-
structions and the safety notes are read
completely and the instructions con-
tained therein are strictly followed.
The symbols used have the following meaning:
DANGER:
Operational danger or improper usage that can
cause serious personal injury.
CAUTION:
Operational danger or improper usage that can
lead to minor personal injury, but cause major
material damage, financial loss or environmental
damage.
Laser radiation
Do not stare into beam
Laser Class 2
according to IEC/EN 60825-1: 2001
Danger of blinding by the laser beam.
Do not look into the laser beam and do not aim the
beam at other persons or animals.
DANGER:
This measuring tool uses class 2 laser irradiation in
accordance with IEC 60825-1: 2007 and FDA 21
CFR Ch. I §1040: 2004.
Protect the battery charger from rain
and moisture. The penetration of water
in a battery charger increases the risk of
electric shock.
J Do not look into the laser beam and do not
unnecessarily aim the beam at other persons
or animals. The natural corneal reflex is not a
sufficient protective measure.
J Make sure that persons within the operating
range are warned not to stare directly into the
laser beam.
J Always switch the laser off when not in use. A
laser that is switched on increases the danger of
someone else accidentally staring into the laser
beam.

For Your Safety

J Do not look into the laser beam with optical
aids, such as, e.g., binoculars. Optical aids
can focus the laser beam in a dangerous man-
ner for the eye.
J Keep the device out of the reach of children.
They can cause danger to themselves and to
others.
J Never open the device yourself. The laser beam
is dangerous for the eyes. Have damages
repaired only through an authorized Würth cus-
tomer service agent.
CAUTION:
J Do not drop the device. Perform check meas-
urements before carrying out important meas-
uring tasks. Pay attention to cleanness of the
laser optics.
J Protect the device against moisture. Penetrat-
ing moisture damages the electronics. Always
store and transport the device in its protective
case.
J Do not remove the instruction label on the bot-
tom side of the housing.
J Do not subject the unit to overly high tempera-
tures or intense sunlight.
J Use the laser only as described under "Use as
Intended". Other usage can lead to serious in-
jury.
J Do not open the laser. Opening the laser will
void the warranty. Modifications on the laser
can cause dangerous laser radiation to emer-
ge.
J Do not store the tool below +4 °C. When war-
ming up, condensate can form on the laser-exit
windows and lead to corrosion on the circuit
board.
J Do not store/operate the tool at temperatures
above +50 °C. At temperatures above +50 °C,
the laser diodes can overheat and be destroy-
ed.
J Use only original Würth accessories. Usage of
accessories that are not recommended can lead
to incorrect measured values.
9