Switching Off; Manual Mode - Würth MLL08 Instrucciones Para El Manejo

Horizontal/Vertical Operation
1
CHARGE
CHARGE
The horizontal and vertical lines can
be combined as desired.
Plumb Beam (downward)
Briefly press the On/Off switch. The plumb beam can
be combined with the horizontal and vertical beams.
Operation with Hand Receiver
Press button 11. The indicator 12 lights up. The beam
can now be located with a hand receiver (e.g. LRL1) at
a distance of up to 90 m.
Note: This function is only available when either the ho-
rizontal or the vertical lines are switched on.

Switching Off

Press the On/Off switch 9 for approx. 3 seconds until
the LEDs flash rapidly.
Anti-Drift-System (ADS)
The ADS function is active for one minute after switching
on.
2
CHARGE
1
CHARGE
CHARGE
2
If the tool moves unnoticed from its original position, the
ADS will indicate this with flashing laser beams. Check
the correct height with reference points. If required, po-
sition the tool again or press the On/Off switch 9 to re-
set the ADS.

Manual Mode

In manual mode, the levelling function is deactivated.
This allows for inclined positioning of the tool.
Note: Level the tool first to rule out possible errors.
Activate manual mode by pressing button 14 and 10 at
the same time. Afterwards, the battery indicator 13 flas-
hes slowly. To return to the standard operating mode,
press buttons 14 and 10 again.
Note: Position the tool level before activating standard
operation.
3
3
CHARGE
11