Basic Operation - Tripp-Lite AV550SC Manual Del Propietário

Basic Operation

1
ON/OFF/TEST
Button
5
Tel/DSL Jacks
1
ON/OFF/TEST Button
• To turn the UPS system on: press and hold the ON/OFF/TEST Button for one
second.* If utility power is absent, pressing the button will cold-start the UPS
system (power it on and supply power from its batteries).
• To turn the UPS system off: press and hold the ON/OFF/TEST Button for one
second.* The UPS system will be completely deactivated.
• To run a self-test: with your UPS system plugged in and turned ON, press and hold
the ON/OFF/TEST button for three seconds.
* If fully charged
CAUTION! To perform a self-test, you must hold the ON/OFF/TEST button
continuously for three seconds. If you release the button too early, you will
turn the UPS system OFF and cut power to connected equipment loads.
The test will last approximately 10 seconds as the UPS switches to battery to test
its load capacity and charge. All LEDs will be lit. See LED descriptions below to
determine the results of the self-test.
Note: You can leave connected equipment on during a self-test.
CAUTION! Do not unplug your UPS system to test its batteries. This will
remove safe electrical grounding and may introduce a damaging surge into
your network connections.
The ON/OFF/TEST button also functions as a recycle/reset button with sequential
outlet startup (including an approximately 60-second router outlet delay) for proper
modem and router rebooting.
2
ON/OFF LED: This green LED lights continuously to indicate that the UPS system is
ON and supplying your equipment with AC power, either from a utility source or from
the UPS system's internal batteries.
17-05-142-932710.indb 4
2
ON/OFF LED
6
Coax Jacks
4
3
OVERLOAD/
CHECK
BATTERY LED
7
Resettable
Circuit Breaker
4
Battery Backup /
Surge Protected
Outlets
8
12V DC
Connector
6/2/2017 11:48:04 AM