Testing Your Fan - Craftmade Riverfront RVF52 Guia De Instalacion

10. Light Kit Assembly (Optional). (cont.)
Replace lock washer and hex nut on threaded rod.
Tighten hex nut over lock washer so that the switch
housing cap fits securely on the light kit fitter.
Connect WHITE wire from light kit fitter to WHITE
wire from switch housing. Connect BLACK wire
from light kit fitter to BLACK (or BLUE) wire from
switch housing. Be sure that molex connections
snap together completely.
Align holes in switch housing cap with holes in
switch housing. Re-insert screws that were
previously removed. Securely tighten all 3 screws.
Install 2 medium base 9 watt LED bulbs (included).
IMPORTANT: When replacing bulbs, please allow
bulbs and glass shade to cool down before
touching.
Remove finial from threaded rod at bottom of light
kit fitter. Raise glass shade and align threaded rod
with hole in middle of glass shade; push up gently
allowing threaded rod to come through hole.
Secure glass shade to light kit fitter with finial
provided. Do NOT overtighten finial as glass may
crack or break.

11. Testing Your Fan.

It is recommended that you test fan before finalizing
installation. Restore power from circuit box and wall
switch (if applicable). Test fan speeds with the pull
chain labeled FAN. Start at the OFF position (no blade
movement). First pull will set the fan to HI. Second pull
will set the fan to MEDIUM. Third pull will set the fan to
LOW. Fourth pull will re-set the fan to OFF setting. If
applicable, test light with the pull chain labeled LIGHT.
(diagram 1.) If fan and/or light do (does) not function,
please refer to "Troubleshooting" section to solve any
issues before contacting Customer Service.
CAUTION: While it is necessary to lift the cover on the
reverse switch to operate the reverse switch, DO NOT
remove weatherporof cover from reverse switch.
Turn fan completely off before moving the reverse
switch. Set reverse switch to recirculate air depending
on the season:
- LEFT position in summer (diagram 2)
- RIGHT position in winter (diagram 3)
A ceiling fan will allow you to raise your thermostat
setting in summer and lower your thermostat setting
in winter without feeling a difference in your comfort.
Important: Reverse switch must be set either
completely LEFT or completely RIGHT for fan to function.
If the reverse switch is set in the middle position
(diagram 4), fan will not operate.
Attach pull chain extension(s) supplied or custom pull
chain extension(s) (sold separately) to the end(s) of the
pull chain(s).
hex nut
lock washer
switch housing
cap
bulb
reverse switch
(with
weatherproof
cover)
pull chain
extension
diagram 1
diagram 2
page 10
molex connections
threaded rod
finial
light
diagram 3
motor
housing
switch
housing
light kit fitter
glass
shade
fan
pull chain
extension
diagram 4