Canopy Assembly; Blade Assembly - Craftmade Riverfront RVF52 Guia De Instalacion

7. Canopy Assembly.

Raise canopy to hanging bracket and align
slotted holes in canopy with loosened
screws in hanging bracket. Twist canopy to
lock. Re-insert screws that were previously
removed (page 3, Section 4) and secure all
screws with a Phillips screwdriver.

8. Blade Assembly.

WARNING: To reduce the risk of serious
bodily injury, DO NOT use power tools to
assemble the blades. If overtightened,
blades may crack and break.
Time Saver: Washers for blade screws can
be set on each blade screw prior to
installing blades.
Locate 15 blade attachment screws and
washers in a hardware pack. Hold blade arm
up to blade and align holes. Insert 3 blade
attachment screws (along with washers)
with fingers first and then tighten screws
securely with a Phillips screwdriver. Repeat
procedure for the remaining blades.
Remove blade arm screws and lock washers
from underside of motor. If plastic motor
locks are installed with blade arm screws,
discard plastic motor locks (save blade arm
screws and lock washers to secure blade
arms). Align blade arm holes with motor
screw holes and attach blade arm with lock
washers and blade arm screws. Before
securing screws permanently, repeat
procedure with remaining blade arms.
Securely tighten all screws.
NOTE: Tighten blade arm screws twice a
year.
plastic
motor
lock
lock
washers
page 8
hanging
bracket
canopy
motor housing
blade attachment
screws and washers
blade arm
blade arm screws
blade