Operation - Domair FACTORY Instrucciones De Uso

OPERATION

Place the unit on a flat, stable surface, and connect it to a wall outlet.
OFF button: Fan off
ON/SPEED button: Fan on and speed
selection (Low, medium, high).
SWING button: to rotate the front
guard, press the button. To stop the ro-
tation, press the button again.
WIND button: Select ventilation mode:
normal, natural, night
ATTENTION: this command can only
be accessed from the remote control.
Normal: operates at the selected speed
Natural: alternates speeds randomly
Night: gradual reduction of speeds (ap-
proximately 30 minutes per speed, until
reaching the low speed)
Note: the corresponding LEDs light to
indicate the selected mode (natural,
normal, night).
Rev 0-12 11 19
TIMER button: Set the operating time
from 1 hour to 9 hours. Each press of
the key represents 1 hour. The selected
time is displayed on the screen. 5 se-
conds after the last press, the countdown
starts. At the end of the countdown, the
unit will stop automatically.
MIST button: start and stop control of
the mist diffusion.
Note: The humidifier is usually used with
the fan, but it can also be used alone.
ION button: Activation and deactivation
of the ioniser. The ioniser is used to pu-
rify the air: the negative ions generated
by the device (anions) act directly on the
polluting particles suspended in the air
and which are positively charged (posi-
tive ion = cation). The anions capture
the cations by attaching to them and fal-
ling with them to the ground.
Note: The ioniser can only work when
the fan is running.
Fabriqué en Chine Page 26