Kenmore 116.31195 Manual De Uso página 20

REPLACING BELT
WARNING
Always unplug power cord from
electrical outlet before performing
any service on vacuum cleaner.
Replace belt whenever a burning rubber
smell caused by excessive slippage
occurs,
NOTE: See REPLACEMENT PARTS for part
number detail (page 5).
1. Turn off and unplug the vacuum
cleaner.
'2. Lay vacuum cleaner on floor with the
bottom up and nozzle flat.
3. Remove nozzle hose from body by (l)
pressing in locking tab and (2) sliding up
and out of retaining slot (see REMOVING
CLOGS, p. 22-23).
4. Remove the four screws from the
nozzle cover.
Four '
i AUTION
Motor shaft may be hot.
5. Place the vacuum in the upright
position standing on the handle. This witl
minimize wheel interference when
removing nozzle bottom plate. Remove
nozzle bottom plate by rotating upward.
6. Lay vacuum cleaner on floor with the
bottom up with nozzle flat.
7. Remove agitator by carefully lifting
out.
Motor Shaft gitator
Belt
8. Remove worn or broken belt.
9. Clean agitator (see CLEANING
AGITATOR, p. 22).
- 20 -