Scan Procedure - Canon DR-5020 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Scan Procedure

The procedure for scanning a document varies according to which feed mode is
set on the scanner.
You can choose from the following four feed modes using the Feeding Option key.
Remote mode (default)
This mode is best suited to scanning only one document stack.
In this mode, the scanner starts scanning when you instruct scanning in the
application with the document loaded on the scanner.
Semi-Auto
This mode is best suited to continuously scanning different-size documents in
separate stacks while adjusting the document guide.
In this mode, the scanner starts scanning when you instruct scanning in the
application and press the Start key on the scanner with the document loaded in
the scanner.
When the scanner has finished scanning a stack of documents, load the next
stack and press the Start key to continue scanning.
Auto
This mode is best suited to continuously scanning a stack of same-size
documents.
In this mode, the scanner automatically starts scanning when you load the
document after instructing scanning in the application.
When the scanner has finished scanning a stack of documents, load the next
stack. The scanner automatically continues scanning.
Manual
In this mode, you load the document one page at a time after you have
instructed start of scanning on the computer.
Use this mode to feed documents that are not fed well (e.g. paper quality that
is more likely to cause double feed) when loaded as a stack.
The following describes each of scan procedures according to the feed mode.
3.2 Document Feeding and scanning
39

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Dr-5080c

Tabla de contenido