Operation For Drill/Driver - Craftsman 125.21417 Manual Del Usuario

Ensemble de combinación des taladro-destornillador y destornillador de impacto con batería de iones de litio de 20v máx
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATION FOR DRILL/DRIVER

This product will accept Craftsman 20V
Max powered by DieHard slide-type
lithium-ion battery packs. For complete
charging instructions, refer to the Operator's
Manual for the battery packs and chargers.
WARNING:
To prevent accidental
starting that could cause serious personal
injury, always remove the battery pack from
the tool when assembling parts, making
adjustments, installing or removing bit,
cleaning, or when it is not in use.
TO ATTACH BATTERY PACK
See Figure 2, page ii
To install the battery pack, align the tongue
on the battery pack with the groove in the
housing and slide it into place. Insert it all the
way until it locks in place with a click.
NOTICE:
Make sure that the latch on the
battery pack snaps into place and the battery
pack is secured to the tool before beginning
operation. Improper assembly of the
battery pack can cause damage to internal
components.
TO DETACH BATTERY PACK
See Figure 2, page ii
To remove the battery pack, slide it from the
tool while pressing the button on the front of
the pack.
WARNING:
Battery tools are always in
operating condition. To prevent accidental
starting, always set the direction-of-rotation
selector to the OFF position when the tool is
not in use or when carrying the tool at your
side. Always carry the tool by its hand grip.
VARIABLE-SPEED TRIGGER SWITCH
See Figure 3, page ii
To turn the tool ON, depress the trigger
switch. To turn it OFF, release the
trigger switch.
The variable-speed trigger switch delivers
higher speed with increased trigger pressure
and lower speed with decreased trigger
pressure.
DIRECTION-OF-ROTATION SELECTOR
(FORWARD / CENTER-LOCK / REVERSE)
See Figure 4, page ii
The direction of bit rotation is reversible and
is controlled by a selector located above the
trigger switch. With the tool held in normal
operating position, as shown in Figure 4.
1. Position the direction-of-rotation selector
to the left of the tool for forward rotation.
2. Position the direction-of-rotation selector
to the right of the tool for reverse.
3. Set the selector in the OFF (center-
lock) position to reduce the possibility of
accidental starting when tool is not in use.
NOTICE:
To prevent gear damage, always
allow the tool to come to a complete stop
before changing the direction-of-rotation.
NOTICE:
The tool will not run unless the
direction-of-rotation selector is engaged fully
to the left or right.
ELECTRIC BRAKE
To stop the tool, release the trigger switch
and allow the tool to come to a complete
stop. The electric brake quickly stops the
chuck from rotating. This feature engages
automatically when you release the trigger
switch.
LED WORKLIGHT
See Figure 5, page ii
The LED worklight, located above the
trigger switch of the drill, will illuminate
when the trigger switch is depressed. This
provides additional light on the surface of the
workpiece. The LED worklight will turn off
when the trigger switch is released.
KEYLESS CHUCK
See Figure 6, page ii
The drill has a keyless chuck to tighten or
release bits in the chuck jaws. The arrows on
the chuck indicate the direction in which to
rotate the chuck in order to GRIP (tighten) or
RELEASE (open) the chuck jaws on the bit.
11 ― English

Publicidad

Tabla de contenido
loading

Tabla de contenido