Features; Assembly; Operation - Craftsman 315.ID2030 Manual Del Operador

PRODUCT SPECIFICATIONS
Anvil ...............................................................1/2 in. Square
No Load Speed ..................................0-2,900 r/min. (RPM)
WARNING:
Do not use this product if it is not
completely assembled or if any parts appear to
be missing or damaged. Use of a product that is
not properly and completely assembled or with
damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-932-3188 for assistance.
WARNING:
Do not allow familiarity with this
product to make you careless. Remember that a
careless fraction of a second is sufficient to inflict
serious injury.
WARNING:
Always remove battery pack from the
tool when you are assembling parts, making ad-
justments, cleaning, or when not in use. Removing
battery pack will prevent accidental starting that
could cause serious personal injury.
WARNING:
Always wear eye protection with side
shields marked to comply with ANSI Z87.1, along
with hearing protection. Failure to do so could
result in objects being thrown into your eyes and
other possible serious injuries.
WARNING:
Do not use any attachments or ac-
cessories not recommended by the manufacturer
of this product. The use of attachments or ac-
cessories not recommended can result in serious
personal injury.
APPLICATIONS
You may use this tool for the purposes listed below:
 Driving nuts and bolts using an impact socket

FEATURES

Torque ......................................................... Up to 300 ft.lb.
Impacts Per Minute .................................................0-3,200

ASSEMBLY

WARNING:
product or create accessories or attachments
not recommended for use with this product. Any
such alteration or modification is misuse and
could result in a hazardous condition leading to
possible serious personal injury.

OPERATION

VARIABLE SPEED SWITCH TRIGGER
See Figure 1, page i.
The variable speed switch trigger delivers higher speed with
increased trigger pressure and lower speed with decreased
trigger pressure.
To turn the tool ON, depress the switch trigger. To turn it
OFF, release the switch trigger and allow the anvil to come
to a complete stop.
NOTE: A whistling or ringing noise coming from the switch
during use is a normal part of the switch function.
DIRECTION OF ROTATION SELECTOR
(FORWARD/REVERSE/CENTER LOCK)
See Figure 1, page i.
Set the direction of rotation selector in the OFF (center
lock) position to lock the switch trigger and help prevent
accidental starting when not in use.
Position the direction of rotation selector to the left of the
switch trigger for forward operation. Position the selector to
the right of the switch trigger to reverse the direction.
NOTE: The tool will not run unless the direction of rotation
selector is pushed fully to the left or right.
NOTICE:
the anvil to come to a complete stop before
changing the direction of rotation.
7 - English
Do not attempt to modify this
To prevent gear damage, always allow