Troubleshooting Chart - STA-RITE US42518M Manual De Instalacion, Operacion & Partes

TROUBLESHOOTING CHART

SYMPTOM
Pump won't start or run.
Pump operates but
delivers little or no water.
Sta-Rite Industries warrants to the original consumer of the products listed below, that they will be free from defects in material and work-
manship for the Warranty Period from the date of original installation or manufacture as noted.
Product
Water Systems Products – jet pumps,
small centrifugal pumps, submersible pumps
and related accessories
Hydro-Flow Filters
Signature 2000
Pro-Source
Pro-Source
Sump/Sewage/Effluent Products
Our warranty will not apply to any product that has been subject to negligence, misapplication, improper installation or maintenance. In
the event a three phase submersible motor is operated with single phase power through a phase converter, or if three-leg ambient com-
pensated, extra-quick trip overload relays of recommended size are not used, our warranty is void.
Buyer's only remedy and Sta-Rite Industries' only duty is to repair or replace defective products (at Sta-Rite Industries' choice). Buyer
agrees to pay all labor and shipping charges associated with this warranty and to request warranty service through the installing dealer
as soon as a problem is discovered. If warranty service is requested more than 30 days after the Warranty Period has ended, it will not
be honored.
STA-RITE INDUSTRIES SHALL NOT BE LIABLE FOR ANY CONSEQUENTIAL, INCIDENTAL, OR CONTINGENT DAMAGES
WHATSOEVER.
THE FOREGOING WARRANTIES ARE EXCLUSIVE AND IN LIEU OF ALL OTHER EXPRESS WARRANTIES. IMPLIED WAR-
RANTIES, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PAR-
TICULAR PURPOSE, SHALL NOT EXTEND BEYOND THE WARRANTY PERIOD PROVIDED HEREIN.
Certain states do not permit the exclusion or limitation of incidental or consequential damages or the placing of limitations on the dura-
tion of an implied warranty, therefore, the limitations or exclusions herein may not apply. This warranty sets forth specific legal rights and
obligations, however, additional rights may exist, which may vary from state to state.
Supersedes all previous publications.
PROBABLE CAUSE(S)
Pump is not plugged in.
Blown fuse or breaker.
Low line voltage.
Defective motor.
Restricted discharge
(obstacle or ice in piping).
Restricted intake.
Low line voltage.
Worn or plugged impeller.
Anti-airlock hole is plugged.
LIMITED WARRANTY
® Fibrewound Tanks
TM Steel Pressure Tanks
TM Epoxy-Lined Tanks
Sta-Rite Industries, 293 Wright St., Delavan, WI 53115
CORRECTIVE ACTION
Check and see if pump is plugged in to a proper outlet.
If blown, replace with fuse of proper size or reset breaker.
If voltage under recommended minimum, check size of
wiring from main switch on property. If OK, contact power
company or hydro authority.
Replace pump.
Remove pump and clean pump and piping.
Remove the pump and clean out the intake screen.
If voltage under recommended minimum, check size of
wiring from main switch on property. If OK, contact power
company or hydro authority.
Replace pump.
Turn off the pump, clean out the anti-airlock hole, and
restart the pump.
Warranty Period
whichever occurs first:
1 year from date of original installation, or
2 years from date of manufacture
1 year from date of purchase
5 years from date of original installation
5 years from date of original installation
3 years from date of original installation
1 year from date of original installation, or
2 years from date of manufacture
4