Replacing The Led - Toto LLT152 Instructivo

To replace the LED:
1
Turn the wall and power adaper switches
to the off position. Disconnect the LED
connector from the power adapter
connector.
2
Loosen the four screws on the lighting
cover and slide the cover as shown.
3
Replace the LED with a new one. Attach
the LED along the cable guides on the
cover as shown.
NOTE: When attaching the LED, make sure the upper and
lower sides of the LED are positioned correctly.
4
After the LED is attached, replace the cover using the same procedure
as in Step 2. Secure the screws and check that it is assembled securely.
5
Turn on the wall and power adapter
switches to confirm that the LED
is lighting correctly.

REPLACING THE LED

Disconnect Disconnect
bracket
Connector Connector
With 9 cable guides
LED LED
Lighting (LED) cover
LED unit LED unit
Up Up
Down Down
LED light source LED light source
ENGLISH
Lighting
(LED) cover
4