Installation; Mounting Instructions; Wallmount; Standalone Installation - Tripp-Lite B118-302-R Manual Del Propietário

2. Installation

2.1 Mounting Instructions

The B118-302-R and B118-304-R come with mounting hardware that allows them to be mounted in a variety
of ways. The following images show the different ways the included mounting brackets can be attached for
different mounting methods. Note: The B118-304-R can also be mounted to a Tripp Lite B132-004-RB 1U
Rackmount Bracket. Up to 3 B118-304-R local units can be connected to a B132-004-RB.

Wallmount

19" Rackmount

2.2 Standalone Installation

Note: The max distances referenced in these instructions have been tested using a 12-bit, 1080p, 60Hz source
and 28 AWG HDMI cables. Longer distances between the splitter and the connected monitors are achievable
using 24 AWG HDMI cable and/or a source with lesser resolution specifications. Likewise, sources with higher
resolutions will require a shorter distance between the splitter and the connected monitors.
1
Connect the HDMI source to the HDMI input on the splitter using the included HDMI cable (B118-302-R
only) or a Tripp Lite P568-Series HDMI Cable. The distance between the source and the splitter must not
exceed 16 ft. (5 m).
2
Connect a monitor to an available output port on the splitter using a Tripp Lite P568-Series HDMI Cable.
A Tripp Lite P566-Series HDMI to DVI-D Single-Link Cable can be used to connect a DVI-D single-link
monitor*. Repeat this step for each additional monitor you are adding. The distance between the splitter
and the connected monitor must not exceed 25 ft. (7.5 m).
3 Connect the included power supply to the splitter, and plug it into an appropriate power source. It is
recommended that you plug the power supply into a Tripp Lite Surge Suppressor. When powered on, the
power LED will illuminate to indicate the unit is receiving power. The output LEDs will illuminate to
indicate a signal is being transmitted from source to display.
*DVI monitors will not provide audio when receiving a signal from the splitter.
201007040 93-3030.indb 3
Pole Mount
3
8/11/2010 11:00:40 AM