Standard Installation - Tripp-Lite B116-002A Manual Del Usuario

Standard Installation

In a standard installation, there is only one splitter being used to connect two
(B116-002A and B116-002A-INT) or up to four (B116-004A) sets of monitors and
speakers. The following rules apply to a standard installation:
• The distance between the source and the splitter must not exceed 16 ft. (5 m).
• For source video resolutions anywhere from 1600 x 1200 @ 60 Hz to 1920 x
1200 @ 60 Hz. The distance between the splitter and the connected monitor and
speakers must not exceed 49 ft. (15 m). The video distance can be extended by
using a B120-000 DVI extender. The B120-000 can be located up to 65 ft. (20 m)
from the splitter and 16 ft. (5 m) from the connected monitor.
• For source video resolutions lower than 1600 x 1200 @ 60 Hz. The distance
between the splitter and the connected monitor and speakers must not exceed
65 ft. (20 m). The video distance can be extended by using a B120-000 DVI
extender. The B120-000 can be located up to 114 ft. (35 m) from the splitter and
16 ft. (5 m) from the connected monitor.
• The B116-002A, B116-002A-INT and B116-004A are designed for monitor refresh
rates of 60 Hz.
1. Make sure the DVI and Audio source is powered OFF.
2. Connect the DVI and Audio source to the input ports on the splitter using a Tripp Lite
DVI with 3.5 mm Audio Cable (P560-XXX-A Series), or a Tripp Lite Single-Link DVI
Cable (P561-Series) and 3.5 mm Audio cable (P312-Series).
4