NAMCO GATOR PANIC Manual Del Operador página 52

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 10
The PC Boards are sensitive to static electricity. Ensure anti-static procedures are
followed when handling the PC Boards.
When refitting the Alligator Assy ensure that the Assy is in the backmost position
and the distance between the upper mouth and the field is 47-55mm.
(see 6-6 page 48 for adjustment.)
1.
Remove the Alligator Assemblies.
2.
Remove the Playfield
3.
Disconnect the connector of the Drive Assy.
4.
While lifting the hook of the Lock Finger, slide the Sensor Wing in the direction of
the arrow as shown below.
5.
Remove 2off hex head screws (M6x35), with flat and spring washers, and
remove the Drive Assy. If the Drive Assy is to be replaced, remove the 2off
rawlnuts (M6) for fitting to the new assembly.
6.
Reassemble in reverse order.
Connector
Hex head screw
(M6x35)
Rawlnut (M6)
Connector
(see 6-5 page 47)
(see 6-8 page 50)
Sensor Wing
2
Page 52
Lock Finger
1
Hex head screw
(M6x35)
Rawlnut (M6)

Publicidad

Tabla de contenido
loading

Tabla de contenido