NAMCO GATOR PANIC Manual Del Operador página 54

1. Remove the Drive Assy.
2. Unsolder the wires from the Solenoid. (Note the positions of each wire so that
they are refitted correctly on the new Solenoid).
3. Remove the button head screw (M3x12) and nylon nut, 2off socket head screw
(M2.6x5) and remove the Solenoid.
4. Refit the Solenoid with Diode attached, and reconnect the solenoid wires as
shown below.
5. Refit the Drive Assy to the cabinet.
Violet
White/Violet
Diode
(attached to
solenoid)
Violet
White/Violet
(see 6-10 page 52)
Button head screw
(M3x12)
Nylon nut
Socket head screw
(M3)
Solenoid
Page 54
Lock Finger
(M2.6x5)