Minimum System Requirements; Parts List - Elite Realtour Instrucciones Para El Uso

equipment generates strong magnetic waves
and interference that may give rise to incorrect
readings. Do not use the device and the conso-
le within a distance of about one and a half
metres from other transmitters.
Do not use other wireless equipment at the
same time. This may give rise to incorrect
measurements. Do not expose the unit and the
console to direct sunlight for long periods
when they are not in use. Check the position
and assembly conditions of the frequency sen-
sor and magnet at regular intervals. Never use
chemical detergents (benzene or thinners) on
any part of the Elite RealTour.
Your RealTour electronic trainer is made of the following components:
N°1 RT Unit frame – Ref. A
N°1 Unit support plate – Ref. B
N°1 M8x70 screw –Ref C
N°1 ø8 washer – Ref. D
N°1 M8 nut - Ref. E
N°1 Ferrule - Ref. F
N°1 Left pin bush – Ref. G
N°1 Right pin bush – Ref. H
N°1 Fixing Lever – Ref. I
N°1 Resistance unit – Ref. J
N°2 M6x16 Screw – Ref. K
N°2 ø6 washer – Ref. L
N°1 Hex key

MINIMUM SYSTEM REQUIREMENTS

Processor:
Operative system:
Hard disk:
Ram:
Monitor:
Drive:
Graphic card:
Various:

PARTS LIST

N°1 Handlebar console – Ref. M
N°4 Standard feet – Ref. N
N°4 Ritmo feet – Ref. O
N°1 Cadence sensor - Ref. P
N°1 Magnet – Ref. Q
N°1 PC-Console USB cable – Ref. R
N°1 Console-Resistance Unit 8 pin cable – Ref. S
N° 2 Dvd-Rom – Ref. T
N°1 Cadence sensor instruction sheet – Ref. U
N°1 Instruction manual – Ref.V
N°1 Travel Block – Ref. W
N°1 Quick Release – Ref. X
N°1 Power charger - Ref. Y
Pentium IV @ 2,4 Ghz
XP, Vista o 7
7200rpm
512 MB
1024x768
DVD-ROM
32MB of memory
1 free USB port
EN
19