ARIETE Vapori aspira Instrucciones De Empleo página 57

interno_GB 14-09-2004
Connector (3), filter (18) and sponge (20)
Remove the water tank from its seating using the
two rear connections.
Remove the connector (3) by pulling it upwards.
Take the filter (18) out from inside the tank, remo-
ving it from its grille. If necessary, rinse the filter with
running water; leave it to dry and then refit it.
Split the connector (3) into its four parts and clean
each piece thoroughly.
CAUTION: When splitting the connector into
parts, take great care not to damage it in
any way.
To reassemble, fit all parts together, inserting the
tabs in the relevant slots.
Remove the sponge (20) from its housing in the
appliance body; wash it with soap and water and
leave it to dry.
CAUTION: Do not allow anything to fall acci-
dentally into the sponge housing; this could
adversely affect appliance operation.
15:43 Pagina 55
55