Cleaning The Rubber Hose And Float - ARIETE Vapori aspira Instrucciones De Empleo

interno_GB 14-09-2004
4.3 CLEANING THE RUBBER HOSE
AND FLOAT
If the rubber hose becomes blocked by dirt and the
float does not work correctly, clean as follows:
- remove the water tank (4), lifting it out from its
seating with the relevant handle (1);
- remove the lid (2) of the container, using the two
rear connections;
- upturn the container until all water and dirt have
been emptied out.
Remove the rubber hose by pulling it firmly.
Take out the float.
Fit the float back into its seating, taking care to posi-
tion it as illustrated in the figure.
Fit the rubber hose back into place, taking care to
push it as far as it will go.
15:43 Pagina 57
57