Open The Door; At The End Of Programme - AEG L 75280 FL Manual De Instrucciones

Ocultar thumbs Ver también para L 75280 FL:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

18 www.aeg.com
Before you press button
start the appliance, you can cancel
or change the set of the delay
start.
You cannot set the delay start with
the Steam programme.
CANCEL THE DELAY START
1.
Press button
tor flashes.
2.
Press button
the display shows 0'.
3.
Press button
starts.

OPEN THE DOOR

While a programme or the delay start op-
erates, the appliance door is locked.
To open the appliance door:
1.
Press button
bol in the display goes off.

AT THE END OF PROGRAMME

• The appliance stops automatically.
• The acoustic signals operate.
• In the display
• The indicator of the Start/Pause button
goes off.
4
• The door lock symbol goes off.
• Press button
pliance. After five minutes from the end
of the programme, the energy saving
function automatically deactivates the
appliance.
When you activate the appliance
again, the display show the end of
the last set programme. Turn the
programme knob to set a new cy-
cle.
• Remove the laundry from the appli-
ance. Make sure that the drum is emp-
ty.
• Keep the door ajar, to prevent mildew
and odours.
• Close the water tap.
4
to
4
. The related indica-
5
again and again until
4
. The programme
4
. The door lock sym-
comes on.
to deactivate the ap-
1
2.
Open the appliance door.
3.
Close the appliance door and press
button
. The programme or the
4
delay start continues.
If the temperature and level of the
water in the drum are too high,
the door lock symbol stays on and
you cannot open the door. To
open the door do the steps that
follow:
1.
Deactivate the appliance.
2.
Wait for some minutes.
3.
Make sure that no water is in
the drum.
If you deactivate the appliance, it
is necessary to set the programme
again.
The washing programme is completed,
but there is water in the drum:
– The drum turns regularly to prevent the
creases in the laundry.
– The door stays locked.
– You must drain the water to open the
door.
To drain the water:
1.
If necessary, decrease the spin speed.
2.
Press the Start/Pause button
appliance drain the water and spin.
3.
When the programme is completed
and the door lock symbol goes off,
you can open the door
4.
Deactivate the appliance.
The appliance drain and spin au-
tomatically after approximately 18
hours.
4
. The

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

L 75480 flL 75280 vflL 75480 vfl

Tabla de contenido