End Programming; Memorising Radio Transmitters; Deleting Radio Transmitters; Display Messages - DIMOEL DIMO700 Manual De Instrucciones

9.8 - END PROGRAMMING

To exit the programming and store the settings of the different parameters, it is necessary to follow this procedure:
+
-
-
Press the key until the
I
display shows

10 - MEMORISING RADIO TRANSMITTERS

The device can memorise up to 15 radio transmitters. Proceed as follows:
+
-
Press and hold key

11 - DELETING RADIO TRANSMITTERS

+
-
Press and hold key

12 - DISPLAY MESSAGES

Display Reason
L
The display shows the letter
the micro switch on the motor
F
The display shows the letter
H
The display shows the letter
A
The display shows the letter
+
-
Press and hold the key
I
for 5 seconds: flashes
+
-
The dot appears on the
display after approx. 1
second
+
-
The dot appears on the
display after approx. 1
second
L
when the actuator is working normally and the red cam positioned on the chain activates
F
when the door encounters an obstacle
H
when the encoder or the control unit is malfunctioning
A
when the photocell intervenes
- 24 -
+
-
Release the key: the
segments of the display
illuminate one at a time
0
until showing
+
-
Release the key and press the remote control button
twice: the device emits a BEEP and the dot is turned off
to confirm memorising has been successful
+
-
Hold the key until the
display is turned off : the
remote controls have been
deleted.