Attaching The Pressure Cuff; Measuring Posture - GERATHERM desktop Instrucciones De Uso

Preparation for Use

Attaching the Pressure Cuff

1. Wrap the cuff around the left
arm. The arm should be bare
skin.
2. Fasten the cuff. Don't pull it
strongly and make the cuff too
tight. The cuff's edge should
be approximately 1 inch from
crook of the arm.
3. Attach the cuff on the right
hand as shown in the fi gure if it
is not possible to measure on
the left arm.

Measuring Posture

1. Sit upright and ensure that the
measuring site is at heart level.
Relax and measure in a natural
position.
EN
2. Measure and record blood pressure at the same time
every day to establish your blood pressure pattern.
AC Adapter (accessory)
Use the device only with a medical approved stabi-
lized AC adapter (Input: 100~240 V, AC, 60/50Hz;
Output: 6V, DC, 800mA).
Note:
1. No batteries are required during operation using
the AC adapter.
2. If AC adapter power is interrupted during meas-
urement, the device must be reset by discon-
necting the AC adapter from the device.
3. Only use medical approved adapters that com-
ply with the specifi cations in this manual. Using
other adapters could cause damage your blood
pressure monitor.
30