Installing The Line Cutter (Ms-30 U, Ms-30 C, Lt-30); Lengthening The Line; Replacing The Line - Dolmar LT-30 Manual De Empleo Y De Seguridad

Installing the line cutter
(MS-30 U, MS-30 C, LT-30)
10
LT-30
G
Adjusting the line
H

Replacing the line

17 18
16 15
I
Always switch off the engine and disconnect the spark
plug cap before replacing the line!
- Press locking device (I/10) and turn housing cover (I/16)
clockwise as far as it will go.
- Remove housing cover (I/16) and push button (I/15) from
housing (I/11). Take spool (I/18) out of housing and remove
remaining bits of line. Leave spring (I/13) and line sleeves
(I/12) in the housing.
12
STOP
10
MS-30 U
MS-30 C
9
STOP
19 12
14 13 12 11 10
The line cutter and its mounting screw are included in the
accessory pack.
- The picture shows the line cutter (G/10) mounted on the
cutter guard with the mounting screw.
Note:
If you adjust the length of the trimmer line (see „Lengthening
the line"), the line cutter will automatically cut the lines to
identical length during operation
- You can adjust the line to the right length at any time by
lightly tapping the trimmer head (H/9) against the ground
(direction of arrow). The line cutter automatically cuts off
excess line.
CAUTION: Always switch off the engine and disconnect
the spark plug cap before cleaning the trimmer head or
replacing the line!
- Cut line (diam. .080" x 50 feet, order no.: 369 224 060) to
16.4 feet (5 m) length.
- Pull the line through the line opening on the spool (hole on
winding member) until both ends are the same length. Wind
both lines tightly around the spool in the direction shown
by the arrow (marked on the spool (I/14)) until the ends
are about 4" (10 cm) long.
- Press one line end into the holding slot (I/19); then wind
the other line end a half turn and press it into the other
holding slot.
- Lay the spool in the housing, taking the lines through the
line sleeves. Press spool into the housing and pull on both
line ends so that they come out of the holding slot.
- Replace push button (I/15) and housing cover (I/16) (align
marking on cover (I/17) centrally with locking device (I/10)).
- Press on housing and turn anti-clockwise as far as it will
go.
Warning: check that the cover is firmly in place by turn-
ing it back and forth.