Idle Adjustment - Dolmar LT-30 Manual De Empleo Y De Seguridad

Cold start
1
A
B

Idle adjustment

7
8
C
D
16
2
5 4 3
6
9
- Prime the fuel pump (A/1) by pressing it several times until
you can see fuel in the pump.
- Move the switch (B/3) in the direction of the arrow.
- Set the half-throttle catch and press the throttle (B/6) with
the throttle trigger lockout pressed (B/5) and then press
the catch (B/4). Release the throttle (B/6) and then the
throttle trigger lockout (B/5).
- Turn the choke lever (A/2) to position
- Hold the brushcutter with one hand as shown in Fig. F on
page 15.
- Pull the starter cable slowly until you feel resistance (pis-
ton is just before top dead centre).
- Now pull quickly and forcefully until you hear the first
audible ignition.
- Do not pull out the whole starter cable to its full extent and
do not let the starter handle jump back, but let it slowly
automatically rewind itself.
- Turn the choke lever (A/2) to position
pull the starter cable again until the engine is running.
- Once the engine has started, press the throttle (B/6) all
the way and release it again immediately. The half-throttle
catch will come out and the engine will idle.
- After a short period of running turn the choke lever (A/2) to
position (open).
Warm start
- If the engine is warmed up do not prime the fuel pump.
- Do not turn the choke to position
Stop engine
Move switch (B/3) to the position
Important: The cutting tool must not rotate when the en-
gine is idling! If it does, adjust the idle speed.
- Loosen the screws (C/7) and remove the air filter cover
(C/8).
- Unscrew the adjustment screw (D/9) no more than 1/8 turn
(counter-clockwise).
- Put the air filter cover (C/8) back on and tighten the screws.
CAUTION: The air filter cover (C/8) must be on when you
check the idle speed!
- Repeat the procedure if the cutting tool still rotates during
idling.
(closed).
(half-open) and
(closed).
.
STOP