Block Function; Filter-Holders - La Cimbali M39 GT R2 Uso E Instalacion

When the machine is blocked, a warning message appears
on the display: if the key corresponding to the requested
wash cycle is pressed (key
instructions on the display are followed, the wash cycle is
performed and the machine is no longer blocked.
For example, if there is a "coffee block", the following
message appears on the display:
GROUP 1 LOCKED
EXECUTE WASHING
The number of the "blocked group" blinks on the display
and depends upon the number of machine groups.
CHANGING THE WATER IN THE BOILER - Procedure to carry out at least once a day
Keep a hot water distributor key (12) pressed down for
approximately 5 seconds.
The following message will be displayed: "WATER
CHANGE". The water from the boiler will drain from the
hot water nozzle (8) (60 - 70% ca. of the total capacity).
Dispensing will stop automatically.
After the procedure, the machine will return to its normal

FILTER-HOLDERS -

1
Put a litre of cold water in a
suitable container and add a
dose of detergent.
4
Remove any residue with a sponge and rinse well with
cold water.

Block function

26) or key (28)) and the
2
If the coffee wash circuit key
message will be integrated as shown:
GROUP 1 LOCKED
EXECUTE WASHING
INSERT FILTER HOLDER
When the "INSERT FILTER HOLDER - GROUP 1" message
appears, the block message for Group 1 disappears. The
block messages for groups still to be washed appear in
alternation.
At this point, follow the steps on the previous pages for
the wash cycle.
12
8
5
A
the anchoring spring (A
28 EN
(26) is pressed, the previous
GROUP 1
12
3
holders in this solution for
at least 15 minutes.