Data Menu - Counter Display And Zeroing; How To Access The Programming Mode - La Cimbali M39 GT R2 Uso E Instalacion

21. DATA menu - Counter display and zeroing

Counters are displayed by pressing the
The following message appears on the display (5):
COUNTERS MENU
N° coffee gr. 1
N° coffee gr. 2
N° coffee gr. 3
N° water
N° steam
Parameters calculated are:
- N. coffee (number of coffee beverages)
- N. water (number of times water is dispensed)
- N. steam (number of times steam is dispensed using
the steam button)
- N. steam air TS (number of times steam and air are
dispensed using the turbosteam function)
- N. tot coffee (total number of coffee beverages).

22. How to access the programming mode

N.B. ONLY if the item "Customer Progr." is set on "YES"
and the item "Program. block" is set on "NO".
To access programming press the
message will appear on the display:
CUSTOMER PROG.
KEY MENU
Press one of the dispensing keys on the selection panel (2);
the relative led will remain on.
Use the (30) and
(black line) on the desired line, then press the
Always use the (30) and
setting; at this point there are two possibilities:
2) exit the menu and leave the settings unchanged by
pressing the key (24).
Note: When modifying data, the cursor changes to "
", or a slide bar with maximum and minimum
settings will appear:
(27) key.
+
01234
01234
01234
01234
01234
key (29); the following
(31) keys to position the cursor
key (29).
(31) keys to change the
key
Counters can be zeroed by aligning the cursor on the selected
entry, pressing the
(30) or (31) key.
Press the key (24
The "N. coffee" entry appears for as many times as there
are machine groups.
Note: Parameters that cannot be zeroed are:
- N. tot coffee
Press the key (24) to return to the main menu.
-5
-
If the "Customer Progr." is set to "NO", the following
message will appear on the display:
CUSTOMER PROG.
NOT ENABLED!
20 EN
key (29), and then pressing the
064 +5
+