Programming In Repeat Mode - Tamerica TPI-4900E Manual De Usuario

Guillotina de papel programable con pantalla tactil lcd de 5
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Programming in Repeat Mode

This program is used for repeat cuts with minimal inputs required on the TPI-4900E. In this exam-
ple, we are cutting 12" x 18" cardstock to make full-bleed business cards. NOTE: These meas-
urements are used as an example only and are not meant to be used as a template.
1. Store the values on Memory 1 to cut on the long side. Remember that you can store it from 1-
99. Do this by clicking EDIT followed by MEMORY, then enter the number 1.
2. Trim your document to the optimal size in order to get 6 rows. Keep in mind the cutter can-
not be programmed to cut smaller than 1.57" (this can be done manually) hence only 6 rows
can be achieved. So in this example, enter 17.00 on Total Size to trim your document to 17".
3. Input 2.00 for Size 1 and .50 for Size 2 to program your repeat cuts then press EDIT once
more to save your entered values.
4. Align your document flush on the left-hand side and against the back gauge then press Run.
The cutter will adjust to 17.00 and trim it at that length when you press the cut buttons. On
the next cut, the cutter will adjust to 15" by trimming your entered value for Size 1 (2.00"),
followed by another cut at 14.5" for Size 2 (.50") which is for your bleed area. Repeat the
process until you collect 6 rows of 12" x 2" sheets.
Align documents here
- 10 -
Press 2 cut buttons simultaneously

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido