Programming in Manual Mode
On start-up, the cutter will default to 19.29" as denoted by the Real Size value which essentially
is the current size adjustment. To manually program a cut size, simply do the following:
1. Enter the value on the keypad then press OK. This will be displayed on Input Size and the
back gauge will adjust accordingly. Another way of adjusting the cut size is by pressing the Up
and Down arrows or with the use of the Hand Wheel. Keep in mind it is able to do so only in
small increments so this should really only be used mainly for fine-tuning.
2. After inputting the cut size, align your document making sure it is square against the left-hand
side of your TPI-4900E and the back gauge.
3. Press the 2 cut buttons simultaneously to operate the blade letting go only after both the
blade and the clamp have retracted after the cut cycle.
4. To push your document out, simply press the Push key. It will remain illuminated which means
the cutter will automatically push your document out on succeeding cuts. Pressing it again
one more time will do the opposite. This will be the same for Manual and Quick Mode.
Align documents here
- 7 -
Press 2 cut buttons simultaenously