Machine Operation
1. Securely attach the supplied power cord to the back of the machine and plug the other end into
a properly grounded power outlet.
2. In order to operate the cutter, make sure the emergency stop switch is in the ON position by
moving the knob according to the direction of the arrows (clockwise). Simply push down on the
knob In the event of any emergency where you need to immediately cut power to the cutter.
3. Flip the main toggle switch upwards to the ON position and the control panel display will come
to life. If it does not, go back to step #2. Before operating the cutter, wait for the Back Gauge to
calibrate and check if the blade and paper clamp are in the standby position which should be all
the way up. If not, press UP (=) on paper clamp up/down control until both have retracted after
which you able to proceed to using the cutter.
- 6 -