Tamerica TPI-4900E Manual De Usuario página 11

Programming in Repeat Mode
5. Press EDIT followed by MEMORY then enter the number 2 to store your values to cut on the
short side.
6. Trim your document in order to be able to get 2 rows again keeping in mind the cutter cannot
be programmed to cut smaller than 1.57". For this, we entered 12.00 on Total Size which is
the actual length of the document on the long side.
7. Input 2.25 for Size 1 and 3.50 for Size 2 to program your repeat cuts then press Edit once
more to save your entered values.
8. Align your document flush on the left-hand side and against the back gauge then press Run.
The cutter will adjust to 12.00 and trim it at that length although nothing really will happen
since the document is already 12.00" in length (this part cannot be skipped). On the next cut,
the cutter will adjust to 9.75" by trimming your entered value on Size 1 (2.25") followed by
another cut on 6.25" for Size 2 (3.50") for your bleed area. Repeat the process until you have
2 stacks of 3.5" x 2" cards.
Align documents here
- 11 -
Press 2 cut buttons simultaneously