Instructions For Use; Electric Plates; Safety Devices; Turning The Appliance Off - Angelo Po 0G0PEVTR Instrucciones Del Aparato

2. Instructions for use

GB

2.1 Electric plates

2.1.1 Safety devices

A device inside the plates reduces power in the event of overheating.
Once the cause has been eliminated and plate temperature is reduced,
operation is restored automatically.
2.1.2 Switching on the plates
Select the knob corresponding to the plate:
Rear plate
Plates status LEDs

2.1.3 Turning the appliance off

• Turn the knob to
2
Front plate
power, turn the knob to the value
• to turn the plate's second ring on or off, turn the knob to the
once the outer ring has been switched on or off, the knob automatically
returns to setting 6
• to use lower powers, turn the knob anti-clockwise to the lower settings.
Plates in operation status LEDs;
When a plate is in operation it normally glows, but at the lowest
power settings this may not be the case. For this reason, LEDs
are provided beside the top that light up to indicate the plate in
use.The Plate Status LEDs do not go out until the relative plates
have cooled.
(OFF).
WARNING:
ALWAYS TURN OFF THE MAIN SWITCH AFTER USE.
• turn the knob clockwise to the minimum power
1
setting
• to use higher powers, keep turning the knob
clockwise to the higher settings.
• to set the plate's inner ring at the maximum
6
, i.e. to the maximum power setting.
- 2 -
setting;