Craftsman CMES300 Manual De Instructiones página 8

English
Flush Cutting (Fig. E)
The compact design of the recipro cating saw motor
housing and pivoting shoe permit close cutting to floors,
corners and other difficult areas.
1. To maximize flush cutting capabilities, insert the
blade 7 into the blade clamp collar
the blade facing up.
2. Turn the saw upside down so you are as close to the
work surface as possible.
Fig. E
6
Wood Cutting (Fig. F)
1. Before cutting any type of wood, be sure the workpiece
is firmly anchored or clamped to prevent slipping.
2. Place blade and adjustable shoe
7
work to be cut.
3. Switch on saw motor before starting the cut.
4. Always hold saw firmly with both hands while cutting.
Whenever possible, the shoe must be held firmly against
the material being cut. This will prevent the saw from
jumping or vibrating and minimize blade breakage.
Fig. F
5
7
Metal Cutting (Fig. G)
1. Use a finer blade for ferrous metals and a coarse blade
for non-ferrous materials.
2. In thin gauge sheet metals it is best to clamp wood to
the underside of the sheet. This will ensure a clean cut
without excess vibration or tearing of metal.
3. Avoid forcing cutting blade as this reduces blade life
and causes costly blade breakage.
NOTE: You should spread a thin film of oil or other coolant
along the line ahead of the saw cut for easier operation
6
and longer blade life. For cutting aluminum, kerosene
is preferred.
Fig. G
6 with the teeth of
Pocket Cutting - Wood Only (Fig. H)
Measure the surface area to be cut and mark clearly with a
pencil, chalk or scriber.
• Tip the saw backward until the back edge of the shoe
is firmly on the work surface and the fully extended
moving blade will clear the surface.
7 • Switch motor on, permitting blade to attain
maximum speed.
• Grip handle steadily and begin a slow, deliberate
upward swing with the handle of the saw.
• The blade will begin to feed into material. Always
be sure blade is completely through material before
continuing with pocket cut.
NOTE: In areas where blade visibility is limited, use the
edge of the shoe as a guide.
firmly against
5
Project Tips
• Cut only with sharp blades; they cut cleaner, faster and put
less strain on the motor while cutting.
• When cutting, always ensure that the shoe is resting
against the workpiece. This will improve operator
control and minimize vibration.
• For longer blade life, use bi-metal blades. These
utilize a carbon steel back welded to high speed steel
teeth making the blade more flexible and less prone
to breaking.
Fig. H