Starting; Important; Stopping / Parking - Textron JACOBSEN HR 9016 Turbo Manual De Seguridad Y Operacion

4.4

STARTING________________________________________________________________

IMPORTANT: Do not use starting assist fluids. Use of
such fluids in the air intake system may be potentially
explosive or cause a "Runaway" engine condition and
could result in serious engine damage.
The engine is equipped with an automatic glow plug
system. This system preheats the cylinders to the correct
starting temperature before cranking.
1. Sit in operator's seat, make sure the power take-off
switch (Y) is OFF and the parking brake is engaged.
Remove feet from pedals. Always use the seat belt
when operating tractors equipped with a ROPS.
2. Set throttle lever (M) to half throttle.
3. Turn ignition switch (V) to RUN ( ). The glow plug
indicator (R2) will automatically light, showing the
glow plug system is energized.
At this time the engine oil pressure and battery
warning lights will also come on.
4. Wait until glow plug light goes out, then immediately
turn ignition key to START ( ). Release as soon
as engine starts.
Note: Do not hold key in START position for more
than 10 seconds at a time. After 10 seconds the
starting circuit will shutdown and must be reset by
returning the key to the OFF position.
If engine fails to start, return ignition switch to the
OFF position to reset glow plug timer. Allow 30
seconds between start-up attempts to allow time for
engine starter motor to cool.
4.5

STOPPING / PARKING ______________________________________________________

To stop:
Remove your foot from traction pedal. The tractor will
automatically brake when the traction pedal returns to
neutral.
To park the tractor under normal conditions:
1. Disengage the power take-off switch (Y), raise the
decks and move away from the area of operation.
2. Select a flat and level area to park.
a. Release traction pedal to bring the tractor to a
complete stop.
b. Disengage all drives, lower decks to the ground,
reduce throttle to half and allow engine to oper-
ate at no load for four to five minutes.
5. All warning lights should go off after engine starts.
Note: The hydraulic oil warning light (I) may remain
on until oil has warmed up. Wait until oil has warmed
up and light goes out before operating tractor. If light
remains on even after oil has reached operating
temperature, change
Maintenance manual
M
Y
CAUTION
Permanant damage to the turbocharger may occur if
the engine is shut down without allowing the
turbocharger time to cool.
To prevent damage, operate the engine with no load
and at half throttle for 5 minutes before shutting off
engine.
3. Engage parking brake, stop the engine and always
remove the ignition key.
If an emergency arises and the tractor must be parked in
the area of operation, follow the guidelines outlined by
the grounds superintendent. If the tractor is parked on an
incline, chock or block the wheels.
OPERATION
oil filters. See Parts &
R
V
I
Figure 4A
4
2
12