Descargar Imprimir esta página

Zapf Creation Baby Annabell Sleep Well for babies Manual Del Usuario página 8

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 13
All about batteries/rechargeable batteries:
Use alkaline batteries for best performance and longer life.
Use only the battery type recommended for the unit.
Batteries must only be replaced by an adult.
Insert batteries with the correct polarity (+ and -).
Do not mix different types of batteries or old and new batteries.
The supply terminals are not to be short-circuited.
Do not mix rechargeable and non-rechargeable batteries.
Do not recharge non-rechargeable batteries.
Rechargeable batteries are to be removed from the toy before charging.
Rechargeable batteries are to be recharged only under adult supervision.
When the product is not used for an extended time, switch button to "OFF" position for longer
battery life time. We also recommend removing batteries to prevent possible leakage and damage
to the unit.
If moisture gets into the battery compartment, dry with a cloth.
Exhausted batteries are to be removed from the toy and taken to a special waste collection point.
Do not throw batteries into a fire as they may explode or leak.
Preparation
Insertion of batteries should be done by an adult as follows:
1. Set the switch on the battery compartment to "OFF". (Fig.1)
2. Use a screwdriver to open the battery compartment. (Fig.1)
3. Insert the 3X1.5V AAA(LR03) batteries. Please check if the polarity is correct. (Fig.2)
4. Screw the cover of the battery compartment back on again. (Fig.1)
5. Set the switch on the battery compartment to "PLAY".
Functions
To use the functions of Baby Annabell Sleep Well for babies, slide the switch on the module inside the
doll to PLAY. If you have not saved a personal recording, the doll will play a lullaby. To play a recording,
please read the instructions below under "3. Playing the recording once or multiple times".
1. Personal recording
You can use the Sleep Well for babies doll to record your own stories, songs or sounds. When the
recording on the doll is played, your baby can fall asleep peacefully to the sound of your voice.
To do this, first remove the module from the doll. Slide the switch on the module from OFF to REC.
Pressing the module activates recording with a two-second delay. When the LED display is on, you can
start your recording. You can record for a maximum of five minutes. 30 seconds before the end of the
maximum recording time, the red LED begins to flash and reminds you to end the recording. Once the
30 seconds are up, the LED switches off and the recording is stopped. If you want to interrupt recording,
press the module once. The recording light will switch off. If you press the module again, the light will
switch on again and you can continue your recording. To end the recording before the five minutes are
up, press the module briefly. After recording, slide the switch back to OFF. Your recording is now saved.
2. Deleting a recording
To delete your recording, slide the switch back to REC and press and hold the module. The LED will begin
to flash red. The deletion is followed by a beep. You can then make a new recording as described under
"1. Personal recording". If you do not make a new recording, the lullaby will play again when PLAY is
pressed.
3. Playing the recording once or multiple times
Slide the switch to PLAY. If you have made a recording, the LED will light up red. When the module is
pressed briefly, the light goes off and the recording is played.
Sleep Well for babies gives you the option of repeating the personal recording up to six times. To do
this, in the first 10 seconds after switching to PLAY, press the module as many times as you want the
recording to play. You can play the recording up to six times, corresponding to a maximum duration of
30 minutes.
8

Publicidad

loading

Este manual también es adecuado para:

702925