Installation; Transport And Storage; Unpacking; Installation Requirements - Grundfos Conex DIA-1 Instrucciones De Instalación Y Funcionamiento

9. Installation

9.1 Transport and storage

• Transport the device carefully, do not drop!
• Store at dry and cool location.

9.2 Unpacking

1. Check the device for damage.
Install as soon as possible after unpacking.
2. Do not install or connect damaged devices!
Retain the packing material or dispose of it
Note
according to local regulations.

9.3 Installation requirements

• Dry room
• Room temperature: 0 °C to 45 °C
• Vibration-free location.
If you do not observe the installation
requirements, the device may be
Note
damaged!
The measurements may not be correct!

9.4 Installation in control panel

92
+0.8
92 +0.8
> 20
Fig. 4 Control panel enclosure Conex
Fig. 5 Sensor interface
14
1. Make an opening of 92 + 0.8 mm x 92 + 0.8 mm
2. Slip on the supplied gasket.
3. Insert the Conex
1. Hook the clamps into the tightening cones on the
2. Secure the device from the rear using a
3. Install a separate sensor interface near the

9.5 Installation of wall-mounted enclosure

> 20
®
DIA-1
in the control panel.
®
DIA-1 into the opening from
the front.
Do not damage the gasket!
Caution
The gasket must be fitted exactly!
sides at the top and bottom.
screwdriver.
sensors.
Warning
Switch off the power supply before
installing!
Enclosure class IP65 is only guaranteed if
the terminal cover is correctly sealed, if the
front panel of the terminal enclosure is
closed and the appropriate cable glands or
dummy caps fitted.
Do not damage the terminal cover gasket!
Caution
The terminal cover gasket must fit exactly!
10.5
Fig. 6 Wall-mounted enclosure Conex
198
®
DIA-1