Selection, Configuration And Parameterisation Of The Controller - Grundfos Conex DIA-1 Instrucciones De Instalación Y Funcionamiento

11.6 Selection, configuration and
parameterisation of the controller
It takes two steps to set up the controller:
• First: selection and configuration of the controller
type in the "setup" menu, "controller" submenu.
• Secondly: parameterisation of the selected
controller type in "main menu", "controller"
submenu.
11.6.1 Selection and configuration of the controller
setup
controller
switching
ctrl.
cont.controll
er
Fig. 30 Selection and configuration of the controller
• In the "setup" menu, select the line "controller"
using the [Up] and [Down] buttons, and press
[OK] to switch to the "controller" menu.
34
limit/2-p relay
osition 1/2
3-pos.ctrl.
off
adjustment, see
interpulse controller
off
adjustment, see
interpulse controller
off
limit downward
contact viol.
upward
violation
inter-pul
downward
se ctrl.
control
upward
control
pulse
adjustment, see
freq.ctrl.
interpulse controller
P
ext./ int.
PI
setpoint
PID