5.
Place one end of needle nose pliers on bottom of axle
and other end of pliers on top of e-ring. Seat e-ring by
pressing pliers closed.
6.
Repeat step 3 through 5 to secure second wheel.
8.
To aid support leg assembly, rest generator on cradle,
engine end down. Attach support leg with two
M8 x 16mm cap screws and two locking hex nuts as
shown.
9.
Use two 13 mm wrenches to tighten leg hardware.
Rest generator on wheels and support leg.
10. Center handle bracket on generator frame at support
leg end of cradle, as shown.
11. Use two 13 mm wrenches to attach handle bracket
with two M8 x 45mm cap screws and two locking hex
nuts.
12. Check that all fasteners are tight and the tires are
inflated to the value marked on the tire or within
15 and 40 psi.
BEFORE STARTING THE
ENGINE
Add Oil
CAUTION!
Any attempt to crank or start the engine
before it has been properly filled with the recommended
oil may result in an engine failure.
Section 3: Assembly
To fill your engine with oil:
• Place generator on a level surface.
• Follow the oil grade recommendations and oil fill
instructions given in the engine owner's manual.
NOTE: The generator's revolving field rides on a
prelubricated and sealed ball bearing that requires no
additional lubrication for the life of the bearing.
Add Fuel
WARNING!
fill fuel tank when engine is running or hot.Allow unit
to cool for two minutes before refueling. DO NOT
light a cigarette or smoke when filling the fuel tank.
WARNING!
Always allow room for fuel expansion.
• Place generator on a level surface.
• Follow the fuel grade recommendations and fuel fill
instructions given in the engine owner's manual.
7
NEVER fill fuel tank indoors. NEVER
DO NOT overfill the fuel tank.